MX1508 DC Motor Driver Module Board Dual Channel DC 2V-10V 1.5A 2-Way PWM Speed Dual H-Bridge Stepper Motor Driver L298N

MX1508 DC Motor Driver Module Board Dual Channel DC 2V-10V 1.5A 2-Way PWM Speed Dual H-Bridge Stepper Motor Driver L298N

The motor drive module is suitable for battery-powered smart cars, toy cars, and robots. The power supply voltage is 2V~10V, which can drive two DC motors or a 4-wire 2-phase stepper motor, which can realize forward or reverse rotation, and can adjust the rotation speed. Everyone can provide 1.5A continuous current, the peak current is up to 2.5A, and the thermal protector can automatically recover.

It adopts imported original chip, built-in low on-resistance MOS switch, minimum heat, no heat sink, small size, low power consumption, very suitable for battery power supply.
    (L298N internal transistor switch, low efficiency, high fever, need to add heat sink, large size, L298N is easy to burn).
    Double 1.5A * 2, peak current is 2.5A, built-in thermal protection circuit, after the temperature drops, there is no need to fear that the motor is blocked and burned, and it will automatically recover.
    Small size, light weight, 0 standby current, it is an ideal choice for your car model.

The double H-bridge motor driver can drive two DC motors or 4-wire two-phase stepper motors.
    The module power supply voltage is 2V-10V.
    The signal input voltage is 1.8-7V.
    Single working current 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA).
    Built-in common conduction circuit, when the input pin is left floating, the motor will not malfunction.
    Built-in hysteresis effect (TSD), overheating protection circuit, no need to worry about the motor stalling.
    Product size: 24.7 * 21 * 5 mm (length, width, height), ultra-small volume.
    Mounting hole diameter: 2 mm.

Precautions:

    1. Reverse connection of the positive and negative poles of the power supply will definitely damage the circuit.
    2. When the output is short-circuited to the ground or the output is short-circuited and the motor is blocked, the chip will be overheated, but the voltage close to or exceeds 10V and the peak current is greater than 2.5A may also cause the chip to burn.  

1 * 1.5A mini dual-channel DC motor drive module with PWM speed control outside L298N